Accommodating Different Media Types and Conditions
4
Advanced
Functions
102
Using Sticky Media
Procedure
Press .
Press several times to display the screen shown
on the left.
Press
.
Press several times to display the screen shown
on the left.
Press
.
Press or to select "ENABLE."
Press
to conrm your entry.
Press , then to go back to the original screen.
Description
Some types of media may tend to stick to the platen. Starting printing with the media sticking to the platen
may make normal media feeding impossible and cause the media to jam. When using such media, set the
[MEDIA RELEASE] menu item to "ENABLE." This peels o the media before starting printing if it is stuck to the
platen. Note, however, that media feeding may be unstable when printing is performed after executing this
operation. Leave this menu item set to "DISABLE" unless you specically need to change it.
Default Setting
[MEDIA RELEASE]: DISABLE
MEDIA RELEASE
DISABLE ENABLE
To Next Page
Loading...
Need help?
General