127
6
FAQ
Other Problems
The Printer Unit Doesn't Run
Are the cables connected?
Connect the cables securely.
"Setup Guide"
Is the power switched on?
Switch on the printer's main power, and then press the sub power switch and make sure the sub power switch
lights.
P. 19, "Switch On!"
Is a cover open?
Close the front, left, and right covers.
Is lit?
Output is not performed when is not lit. Close the front cover, lower the loading lever, and then
press
.
P. 42, "Getting Ready to Receive Data from a Computer"
Is the top menu displayed?
Top menu
If the top menu isn't displayed, output doesn't start even when data is sent from the computer. To go to the
top menu, press
, and then press .
P. 42, "Getting Ready to Receive Data from a Computer"
Is a message displayed on the screen?
P. 130, "A Message Appears", P. 132, "An Error Message Appears"
Is lit?
When is lit, operation is paused. To resume, press . turns o and output resumes.
P. 45, "Pausing and Canceling Output"
Has ink run out?
When the screen shown above is displayed, print data cannot be accepted.
If the screen shown above is displayed during printing, the behavior of the printer depends on the [EMPTY
MODE] setting.
When "STOP" is selected: The printing operation is paused.
When "CONT." is selected: A warning beep sounds, and printing continues until the printer has nished
printing the print data it has accepted. In this case, it is also possible to press
and pause printing.
W1200mm
1 2 3 4
5 6 7 8
To Next Page
Loading...
Need help?
General