Fully Utilizing the Media Heating System
4
Advanced
Functions
89
Setting the Drying Time after Printing
Procedure
Hold down and press .
Press .
Press to display the screen shown on the left.
Press
.
Press or to select the drying time.
Press
to conrm your entry.
Press , then to go back to the original screen.
Description
Set the drying time after the 1st page is printed. The next operation is not started until the set time passes.
During drying,
is lit. Press while is lit to nish the drying time and start the next
operation. Also, hold down
while is lit to cancel the output.
You can also make this setting in the software RIP. When you have made the setting in the software RIP, the
software RIP's setting is used.
Default Setting
[DRYING TIME]: 0 min
Using an Optional Dryer
Procedure
Hold down and press .
Press .
Press several times to display the screen shown
on the left.
Press
.
Press or to select "ENABLE."
Press
to conrm your entry.
Press , then to go back to the original screen.
OPTION DRYER
DISABLE ENABLE
To Next Page
Loading...
Need help?
General