125
6
FAQ
The Print-head Carriage Stops Moving
If the print-head carriage (hereinafter "print heads") stops over the platen, take action immedi-
ately to prevent the print heads from drying out.
What to Do First
Switch the sub power off, then back on
again.
If the media is jammed, then also remove
the media.
If the print heads move to the home position
(inside the right cover), it means the opera-
tion has ended successfully.
If the print heads still do not move
Try switching o the main power, then again switching on the main power, followed by the sub power.
If the Print Heads Still Do Not Move
If the print heads still do not move, carry out the following emergency response measure, and then contact
your authorized Roland DG Corp. dealer.
Procedure
Switch off the main power, and then open the front cover.
Remove the right cover.
Click!
To Next Page
Loading...
Need help?
General