19
2
Basic
Operation
Switch On!
Switch On!
WARNING
When output is not being performed, remove any loaded media or switch
off the sub power.
The continued application of heat at a single location may cause the release
of toxic gases from the media or pose a re hazard.
Procedure
Close the front cover.
Switch on the main power.
Switch on the sub power.
Note: Set the menu language and the units of measurement.
P. 112, "Setting the Menu Language and the Units of
Measurement"
Sleep Mode (Power-saving Feature)
This machine is provided with a power-saving feature that switches to a low-power “sleep mode” when a
xed interval passes with no operation. The factory default for the time after which the machine switches to
the sleep mode is 30 minutes. When the machine is in the sleep mode, the sub power switch ashes slowly.
Using the operation panel or sending printing data from the computer when media is loaded in the machine
restores it to the normal mode.
This sleep mode setting can be changed. However, we recommend setting the activation time for the sleep
mode to 30 minutes or less to reduce power consumption and prevent problems such as overheating.
P. 112, "Setting the Activation Interval for Sleep Mode (Power-saving Feature)"
Front cover
Main power switch
Sub power switch
To Next Page
Loading...
Need help?
General