Roland Soljet EJ-640 - Displaying the Amount of Media Remaining

Output Operation Management
5
To Admin- istrators
109
Default Setting
[EMPTY MODE]: STOP
Displaying the Amount of Media Remaining
You can display how much of the media in use is left. By setting the amount of media currently remaining at
the start, the amount remaining will be constantly displayed on the screen until it reaches zero.
Procedure

Press .

Press to display the screen shown on the left.
Press
, then .

Press .

Press or to set the current amount of
media remaining.
Press
to conrm your entry.

Press , then to go back to the original
screen.
Description
If you cancel the setup such as by removing the media or raising the loading lever, the amount remaining at
that time ashes on the screen. Because the amount of media remaining is not updated automatically when
you change the media, redo the setting whenever you change the media. You can also set the machine to
display this menu automatically whenever you change the media. See the next section, "Making Sure to Verify
the Setting for the Amount Remaining Every Time the Media Is Changed."
Note: The remaining amount that is displayed is only an estimate, and its accuracy is not guaranteed.
MENU
SHEET REMAIN
SHEET REMAIN
SET LENGTH
SET LENGTH
0.0m 25.0m
W1200mm Ｌ25.0m
SETUP SHEET
ROLL
Ｌ 25.0m
This display is
updated.
If setup has not been performed,
the set value ashes.