130
6
FAQ
A Message Appears
These are the main messages that appear on the machine's display to prompt correct operation.
They do not indicate any errors. Follow the prompts and take action accordingly.
[PRESS THE ENTER KEY TO CONTINUE]
If the front cover, left cover, or right cover (hereinafter all referred to as "cover") opens during an operation in
which the print-head moves such as printing or cutting, the printer makes an emergency stop.
P. 132, "[CLOSE COVER (FRONT COVER/COVER L/COVER R)]"
When an emergency stop occurs, a message prompting you to close the cover will be displayed on the screen.
Follow the instruction shown on the screen and close the cover. After you close the cover, the above message
appears on the screen. Follow the instruction shown on the screen and press
. The printer recovers
from the error and is then able to continue operations.
[1 ■ 2 ■ 3 ■ 4 ■ 5 ■ 6 ■ 7 ■ 8 ■]
Only a small amount of ink remains. Replace the cartridge indicated by the ashing number with a new cartridge.
[PRESS THE POWER KEY TO CLEAN]
This message appears when the machine has been unused for about one month. Switch on the sub power
once a month.
P. 80, "When Not in Use for a Prolonged Period"
[SHEET NOT LOADED PRESS SETUP KEY]
Load media. This message appears when an attempt to perform a printing test was made while no media
was loaded.
[END OF THE SHEET]
The trailing edge of the media was detected during operation. Press any key on the operation panel to clear
the message. Load new media.
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged uid collects in the drain bottle. To clear the message, press
. If this screen appears, go to the [DRAIN BOTTLE] menu and discard the discharged uid in the bottle.
P. 52, "Disposing of Discharged Fluid"
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain bottle, and then press .
P. 52, "Disposing of Discharged Fluid"
[NOW HEATING...]
Wait until the media heating system reaches the set temperature. Printing starts when lights. You can
stop printing by holding down
for one second or longer while this is displayed. Pressing
makes printing start immediately, without waiting to reach the set temperature.
[REMOVE MEDIA CLAMPS]
This appears if is pressed while the media clamps are attached. Remove the media clamps, and
then press
.
To Next Page
Loading...
Need help?
General