Outputting
2
Basic
Operation
40
Printing Tests and Normal Cleaning
Before you carry out actual printing, perform a printing test to ensure no dot drop-out occurs. If dot drop-out
occurs, perform cleaning of the print heads (Normal Cleaning).
1.
Set test print orientation.
Note: The factory default setting for test print orientation is "Portrait." When making continuous test prints, it
is possible to select print orientation of "Portrait" or "Landscape" from the second print onward. However, if
using the optional media take-up system, test prints will be printed in "Portrait" orientation regardless of the
print orientation setting.
P. 105, "Using the Media Take-up System"
Press .
Press several times to display the screen shown
on the left.
Press
.
Press several times to display the screen shown
on the left.
Press
.
Press and to select [SCAN].
Press
to conrm.
Press to go back to the original screen.
2.
Make a test print.
Set the output-start location.
P. 38, "Setting the Output-start Location"
MENU
SUB MENU
SUB MENU
TEST PRINT POS
TEST PRINT POS
FEED SCAN
When performing continuous test prints, there is no need to set the printing-start location from the
second print onward. However, the printing-start location will be restored to its default and it will be
necessary to reset it if any of the following operations are made between prints:
Cutting a sheet
Printing created data
Setting the media free
To Next Page
Loading...
Need help?
General