113
Chapter 5 Playing Along with Patterns
Chapter 5
Editing a Pattern
You can edit user patterns.
User patterns in which Pattern Lock (p. 119) set to “ON”
cannot be edited. A warning screen appears in the display if
you attempt to make such changes in subsequent operations.
fig.06-043
For instructions on turning off the Pattern Lock, refer to p.
119.
Copying a Pattern [COPY]
Copy the pattern as is to the User patterns.
fig.06-044.e
Part instruments and volume and other settings are
copied just as they are. When copying only the
performance data, refer to “Copying Part of a Pattern by
Measures” (p. 114).
fig.06-045
1. Press [PATTERN], then [F3 ( MENU)].
[PATTERN] lights, and a pop-up menu appears.
2. Press [INC/+] or [DEC/-], rotate the VALUE dial, or
press CURSOR [ ] or [ ] to move the cursor to
“EDIT.”
3. Press [F3] to confirm your choice.
The “PATTERN EDIT” screen appears.
4. Press CURSOR [ ] to move the cursor to “EDIT.”
5. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select “COPY.”
The “COPY” screen appears.
6. Press CURSOR [ ] to move the cursor to “SOURCE.”
7. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
choose the copy-source pattern.
8. Press CURSOR [ ] to move the cursor to “DEST.”
9. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
choose the copy-destination pattern.
10.Press [F3 (COPY)].
The confirmation screen appears.
fig.06-046
11.Press [F3 (EXEC)].
Press [F1 (CANCEL)] to cancel the operation.
SOURCE: 1–800
This specifies the pattern to be used as the copy source.
Indicated from left to right are the pattern number and
pattern name.
DEST: 701–800
This specifies the User pattern to be used as the copy
destination.
Indicated from left to right are the pattern number and
pattern name.
SRC
12 643785
DEST
12 643785
To Next Page
Loading...
Need help?
General