26
Before You Begin Playing
This section explains the connections and settings that you must make
before playing. The explanations given here are based on the assumption
that the TD-8 is set according to factory settings.
Mounting the TD-8 to the Stand
1
Attach the stand holder (included with the optional MDS-7U, MDS-
8, and MDS-10) to the TD-8.
Using the screws attached to the bottom panel, attach the holder so the unit
is oriented as shown in the diagram.
fig.Q1-001.e
2
Attach the TD-8 to the drum stand (MDS-7U, MDS-8, or MDS-10).
For details on assembling the drum stand and attaching the TD-8, refer to
the owner’s manual for the drum stand.
The TD-8 can be restored to
factory settings. Refer to
"Restoring Settings to Their
Default Values" on p. 172.
Use the screws provided
with the TD-8. Use of other
screws may result in
damage to the unit.
To attach the TD-8 to a
cymbal stand or other such
stand, you may want to use
the optional APC-33 All
Purpose Clamp to secure
the stand holder. This
clamp may be used on
cymbal stands with pipes
etween 10.5 and 30
millimeters in diameter.
Wide
Narrow
To Next Page
Loading...
Need help?
General