Roland V-Drums TD-8 User Manual

115
Chapter 5 Playing Along with Patterns
Chapter 5
For more on note numbers and trigger inputs, refer to “NOTE
NUMBERS assigned to each TRIGGER INPUTS” (p. 185).
For example, to copy all parts from Measure 4 to the end
of Measure 6, and then copy this to Measure 1 of the
copy destination, specify as shown below.
fig.06-050
Inserting a Blank Measure
[INSERT]
Insert a blank measure at the specified location in the pattern.
fig.06-055.e
• If you want to add to a performance in progress, record
after using this procedure to insert measures.
• The time signature of the inserted measure is same to the
recorded pattern.
Pattern lengths that exceed 99 measures once changes are
made cannot be specified.
fig.06-056
1. Press [PATTERN], then [F3 ( MENU)].
[PATTERN] lights, and a pop-up menu appears.
2. Press [INC/+] or [DEC/-], rotate the VALUE dial, or
press CURSOR [ ] or [ ] to move the cursor to
“EDIT.”
3. Press [F3] to confirm your choice.
The “PATTERN EDIT” screen appears.
4. Press CURSOR [ ] to move the cursor to “EDIT.”
5. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select “INSERT.”
The “INSERT” screen appears.
6. Press CURSOR [ ] to move the cursor to “PATTERN.”
7. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
select the pattern into which one or more blank measures
are to be inserted.
8. Press the CURSOR [ ] to move the cursor to
“MEASURE.”
Indicated from the left is the first measure, followed by
the number of measures.
Press CURSOR [ ] or [ ] to move the cursor to the
item to be selected.
9. Press [INC/+] or [DEC/-] or rotate the VALUE dial to
specify.
10.Press [F3 (EXEC)].
The confirmation screen appears.
fig.06-057
11.Again, press [F3 (EXEC)].
Press [F1 (CANCEL)] to cancel the operation.
PATTERN: 701–800
This selects the pattern into which one or more blank
measures are to be inserted.
Indicated from left to right are the pattern number and
pattern name.
MEASURE: First Measure-Last Measure
This specifies the measure at which inserting is to begin.
First Measure: 1–98, END
This specifies the measure at which insertion begins.
When “END” is selected, the measures are inserted to
the end.
Number of Measures: 1–99
This specifies the number of measures to be inserted.
For example, to insert two blank measures between
Measure 3 and Measure 4, specify as shown below.
fig.06-058
12 435
12 43
55

Roland V-Drums TD-8 Specifications

General

Brand	Roland
Model	V-Drums TD-8
Category	Drums
Language	English