155
Chapter 9 Features Using MIDI
Chapter 9
CH10 PRIORITY: KIT, PERC
KIT:
When a duplicate note number is received, the
instrument assigned to the drum kit part (the pad
instrument) sounds. Other note number is received, the
percussion part instrument is played.
PERC:
The percussion part instrument is always sounds.
Switching Off Local Control
This setting is required when you wish to record your pad
performance on an external MIDI sequencer.
The performance data from the pad, rather than being sent
directly to the sound module section (Local Control Off), is
first sent to the external sequencer, and then on to the TD-8’s
sound module.
fig.10-012.e
If you make connections and record as shown, with a setting of
Local On, duplicate notes will be re-transmitted to the TD-8
and will not be played correctly.
1. Press [SETUP], then [F2 (MIDI)], then [F1 (GLOBAL)],
and then [F1 (PAGE 1)].
[SETUP] lights, and the “MIDI GLOBAL” screen
appears.
fig.10-013
2. Press CURSOR [ ] or [ ] to move the cursor to
“LOCAL CONTROL.”
3. Press [INC/+] or [DEC/-] or rotate the VALUE dial to set
this to “OFF.”
LOCAL CONTROL: OFF, ON
Stopping Exchange of Program
Change Messages
You can specify whether or not the TD-8 will transmit and/
or receive program change messages to/from an external
device.
1. Press [SETUP], then [F2 (MIDI)], and then [F2 (PROG)].
[SETUP] lights, and the “PROGRAM CHANGE” screen
appears.
fig.10-014
2. Press CURSOR [ ] or [ ], to select the kit to be set.
3. Reception is switched on or off each time [F1] is pressed;
each press of [F2] switches transmission on or off.
fig.10-015
Program changes assigned to the drum kits are set in
“Changing the Kit Numbers Called Up with Program Change
Messages” (p. 157).
TD-8
Sound module
Sequencer
Local Control: OFF
MIDI OUT/THRU
MIDI IN
: Performance data flow route
Trigger → MIDI
comverter
TRIGGER INPUT
To Next Page
Loading...
Need help?
General