• Make sure that all the adjusters contact the oor. Otherwise the cabinet could
move, causing an accident.
• Provide a ventilation space at least 15cm wide behind the cabinet. There are
ventilation holes on the back of the cabinet. Do not block the ventilation holes.
Doing so could trap heat inside resulting in re. It could also result in equipment
damage or cause parts to become exhausted prematurely.
The product is equipped with 2 casters and 2 adjusters.
When installation position / site has been determined, have the adjusters come in direct contact with the oor. Adjust
the adjusters to eliminate any movement in the cabinet.
1 Move the product to the installation site.
2 Bring the adjusters into direct contact with the oor. Use a wrench to align the height of the adjusters until the
cabinet is perfectly level.
3 After setting, turn adjuster nuts upwards to tighten them and secure adjuster heights.
ADJUSTER
Fasten the nuts in an
upward direction.
Keep Casters at floor level -
Adjust to come into contact with floor
ADJUSTER
CASTER
6-2 FIXATION TO SITE
CASTORS
ADJUSTERS
To Next Page
Loading...
Need help?
General
