16-1 GAME BOARD - HANDLING PRECAUTIONS
• To prevent electric shock or IC Board malfunctioning, be sure to turn off the
power for the cabinet when installing or removing the IC Board.
• Extraneous matter such as dust on the IC Board can cause the IC Board to
generate heat and result in a re due to short circuit, etc. Ensure the IC Board
surfaces are always kept clean.
• Keep the IC board well cooled. RINGWIDE is provided with ventilating fans.
Do not block the air outlets of these fans. Also do not place anything closely
to RINGWIDE. Failure to observe these instructions may cause an overheating
and re.
• Always follow the usage conditions from SEGA as well as the usage conditions
for the cabinet you are using for RED ONE (UN COCH). Failure to do so may
cause an overheating and re.
• Be sure to connect the IC Board and connectors completely. Insufcient
insertion can damage IC Board, etc.
• For the IC Board circuit inspection, only the use of Logic Tester is permitted.
The use of ordinary testers is not permitted as these can damage the IC
Board.
• Do not subject the IC Board to static electricity when installing the IC Board
in the cabinet or when connecting wire harness connectors to the IC
Board.
• When soldering buttons, etc. to the wire harnesses, be sure to remove the
wire harnesses from the IC Board so as not to subject the IC Board to heat.
• Some parts are the ones designed and manufactured not specifically
for this product. The manufacturers may discontinue, or change the
specifications of, such general-purpose parts. If this is the case, SEGA
cannot repair or replace a failed product whether or not a warranty period
has expired.
To Next Page
Loading...
Need help?
General
