Siemens SIMATIC PCS 7 CPU 410-5H User Manual

Special functions of the CPU 410-5H
9.10 Type update with interface change in RUN
CPU 410-5H Process Automation
150 System Manual, 09/2014, A5E31622160-AB
CPU as a time master
If you configure the CPU as a time master, you must specify a synchronization interval. You
can select any interval between 1 second and 24 hours.
Select a synchronization interval of 10 s if the CPU is the time master on the S7-400
backplane bus.
The time master does not send time frames until you have set the time. You can set the time
with STEP 7, SFC 0 " SET_CLK", SFC 100 "SET_CLKS" or an interface as time slave (NTP
client / slave).
Reference
Information about time synchronization for PCS 7 is available in the Time Synchronization
manual of the SIMATIC PCS 7 technical documentation at the following address SIMATIC
Process Control System PCS 7, time synchronization (V8.0)
(http://support.automation.siemens.com/WW/view/en/61189664).
9.10
Type update with interface change in RUN
Overview
The S7-410 automation system supports the type update with interface change in RUN.
Gives you the option to update the instances at block types after an interface change and
download the update to the PLC in RUN.
You will find more detailed information on this topic in the
Process Control System PCS 7,
CFC for SIMATIC S7
manual.

Siemens SIMATIC PCS 7 CPU 410-5H Specifications

General

Brand	Siemens
Model	SIMATIC PCS 7 CPU 410-5H
Category	Controller
Language	English