EasyManuals Logo
Home>Siemens>Controller>SIMATIC PCS 7 CPU 410-5H

Siemens SIMATIC PCS 7 CPU 410-5H User Manual

Siemens SIMATIC PCS 7 CPU 410-5H
380 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #238 background imageLoading...
Page #238 background image
Supplementary information
15.4 Configuring with STEP 7
CPU 410-5H Process Automation
238 System Manual, 09/2014, A5E31622160-AB
15.4.2
Configuring hardware
You can create the AS bundle configurations with the PCS 7 wizard.
Another way of achieving a redundant hardware configuration is to initially assemble
one
rack with all components to be implemented redundantly and to assign parameters to them.
The entire rack must then be copied and inserted. You adjust the network parameters
appropriately in the subsequent dialogs.
Special features in presenting the hardware configuration
In order to enable quick recognition of a redundant DP master system or PN/IO system,
each of them is represented by two parallel cables.
15.4.3
Assigning parameters to modules in a fault-tolerant station
Procedure
Assign all parameters of the redundant components identically, with the exception of
communication addresses.
The special case of CPUs
You can only set the CPU0 parameters (CPU on rack 0). Any values that you specify are
automatically allocated to CPU1 (CPU on rack 1). You can set the following values for
CPU1:
Parameters of the DP interface (X1)
Addresses of sync modules
Parameters of the PROFINET IO interfaces

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC PCS 7 CPU 410-5H and is the answer not in the manual?

Siemens SIMATIC PCS 7 CPU 410-5H Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC PCS 7 CPU 410-5H
CategoryController
LanguageEnglish

Related product manuals