Siemens SIMATIC PCS 7 CPU 410-5H User Manual

I/O configuration variants
4.5 Using single-channel switched I/O
CPU 410-5H Process Automation
64 System Manual, 09/2014, A5E31622160-AB
You can use the following interface modules for the I/O configuration at the PROFIBUS DP
interface:
Table 4- 3 Interface modules for use of single-channel switched I/O configuration at the PROFIBUS
DP interface
Interface module
Article No.
IM 152 for ET 200iSP
6ES7152-1AA00-0AB0
IM 153–2 for ET 200M 6ES7 153–2BA82–0XB0
6ES7 153–2BA81–0XB0
6ES7 153–2BA02–0XB0
6ES7 153–2BA01–0XB0
6ES7 153–2BA00–0XB0
Each S7-400H subsystem is interconnected with one of the two DP slave interfaces of the
ET 200M via a DP master interface.
Bus modules for hot swapping
You can use the following bus modules for hot swapping a variety of components:
Table 4- 4 Bus modules for hot swapping
Bus module
Article No.
BM PS/IM for load power supply
and IM 153
6ES7195-7HA00-0XA0
BM 2 x 40 for two modules, 40 mm
wide
6ES7195-7HB00-0XA0
BM 1 x 80 for one module, 80 mm
wide
6ES7195-7HC00-0XA0
BM IM/IM for two IM 153-2/2 FO for
design of redundant systems
6ES7195-7HD10-0XA0

Siemens SIMATIC PCS 7 CPU 410-5H Specifications

General

Brand	Siemens
Model	SIMATIC PCS 7 CPU 410-5H
Category	Controller
Language	English