3 – 1
3 Standard specifications
Qualified Personnel
For the purpose of this instruction manual and these product labels, a "qualified person" is one who is familiar with the
installation, construction and operation of the equipment and the hazards involved and who, in addition, has the following
qualifications:
a) Is trained and authorized to energize, de-energize, clear, ground and tag circuits and equipment in accordance with
established safety practices.
b) Is trained in the proper care and use of protective equipment in accordance with established safety practices.
c) Is trained in rendering first aid.
The circuit breakers are suited for operation in enclosed spaces not subject to operating conditions aggravated by dust, corrosive vapors or
gases. Circuit breakers to be installed in dusty or damp locations must be appropriately enclosed.
The circuit breakers are in conformity with the following standards:
- ANSI C37.13
- ANSI C37.16
- ANSI C37.50
- UL 1066
The electronic trip units are in conformity with the following standards:
- ANSI C37.17
- UL 1066
The cradles are in conformity with the following standards:
- ANSI C37.20.1
- ANSI C37.51
- UL 1066
DANGER
Hazardous voltage.
Will cause death, serious personal injury, or equipment/property damage.
Turn off and lock out all power supplying this device before working on this device.
Only qualified personnel should work on this equipment, after becoming thoroughly familiar with all warnings, safety
notices, and maintenance procedures contained herein and on the devices.
The successful and safe operation of this equipment is dependent on proper handling, installation, operation and
maintenance.
To Next Page
Loading...
Need help?
General
