C
ONFIGURING
P
ROTOCOL
-B
ASED
VLAN
S
11-19
Configuring Protocol-Based VLANs
The network devices required to support multiple protocols cannot be
easily grouped into a common VLAN. This may require non-standard
devices to pass traffic between different VLANs in order to encompass all
the devices participating in a specific protocol. This kind of configuration
deprives users of the basic benefits of VLANs, including security and easy
accessibility.
To avoid these problems, you can configure this switch with
protocol-based VLANs that divide the physical network into logical
VLAN groups for each required protocol. When a frame is received at a
port, its VLAN membership can then be determined based on the
protocol type being used by the inbound packets.
Command Usage
To configure protocol-based VLANs, follow these steps:
1. First configure VLAN groups for the protocols you want to use
(page 8). Although not mandatory, we suggest configuring a separate
VLAN for each major protocol running on your network. Do not add
port members at this time.
2. Create a protocol group for each of the protocols you want to assign to
a VLAN using the Protocol VLAN Configuration page.
3. Then map the protocol for each interface to the appropriate VLAN
using the Protocol VLAN Port Configuration page.
Configuring Protocol Groups
Create a protocol group for one or more protocols.
Command Attributes
• Protocol Group ID – Group identifier of this protocol group.
(Range: 1-2147483647)
To Next Page
Loading...
Need help?
General
