SNMP C
OMMANDS
21-16
• When privacy is selected, the DES 56-bit algorithm is used for data
encryption.
• For additional information on the notification messages supported by
this switch, see “Supported Notification Messages” on page 5-75.
Also, note that the authentication, link-up and link-down messages are
legacy traps and must therefore be enabled in conjunction with the
snmp-server enable traps command (page 21-9).
Example
show snmp group
Four default groups are provided – SNMPv1 read-only access and read/
write access, and SNMPv2c read-only access and read/write access.
Command Mode
Privileged Exec
Example
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
Console#show snmp group
Group Name: r&d
Security Model: v3
Read View: defaultview
Write View: daily
Notify View: none
Storage Type: permanent
Row Status: active
Group Name: public
Security Model: v1
Read View: defaultview
Write View: none
Notify View: none
Storage Type: volatile
Row Status: active
To Next Page
Loading...
Need help?
General
