A
DDRESS
R
ESOLUTION
P
ROTOCOL
(ARP)
36-45
clear ipv6 neighbors
This command deletes all dynamic entries in the IPv6 neighbor discovery
cache.
Command Mode
Privileged Exec
Example
The following deletes all dynamic entries in the IPv6 neighbor cache:
Address Resolution Protocol (ARP)
arp
This command adds a static entry in the Address Resolution Protocol
(ARP) cache. Use the no form to remove an entry from the cache.
Syntax
arp ip-address hardware-address
no arp ip-address
• ip-address - IP address to map to a specified hardware address.
• hardware-address - Hardware address to map to a specified IP address.
(The format for this address is xx-xx-xx-xx-xx-xx.)
Console#clear ipv6 neighbors
Console#
Table 36-7 Address Resolution Protocol Commands
Command Function Mode Page
arp Adds a static entry in the ARP cache GC 36-45
arp-timeout Sets the time a dynamic entry remains in the
ARP cache
GC 36-46
clear arp-cache Deletes all dynamic entries from the ARP
cache
PE 36-47
show arp Displays entries in the ARP cache NE,
PE
36-47
ip proxy-arp Enables proxy ARP service VC 36-48
To Next Page
Loading...
Need help?
General
