U
SER
A
UTHENTICATION
C
OMMANDS
22-4
enable password
After initially logging onto the system, you should set the Privileged Exec
password. Remember to record it in a safe place. This command controls
access to the Privileged Exec level from the Normal Exec level. Use the no
form to reset the default password.
Syntax
enable password [level level] {0 | 7} password
no enable password [level level]
• level level - Level 15 for Privileged Exec. (Levels 0-14 are not used.)
•{0 | 7} - 0 means plain password, 7 means encrypted password.
• password - password for this privilege level.
(Maximum length: 8 characters plain text, 32 encrypted, case sensitive)
Default Setting
• The default is level 15.
• The default password is “super”
Command Mode
Global Configuration
Command Usage
• You cannot set a null password. You will have to enter a password to
change the command mode from Normal Exec to Privileged Exec
with the enable command (page 19-2).
• The encrypted password is required for compatibility with legacy
password settings (i.e., plain text or encrypted) when reading the
configuration file during system bootup or when downloading the
configuration file from a TFTP server. There is no need for you to
manually configure encrypted passwords.
Example
Console(config)#enable password level 15 0 admin
Console(config)#
To Next Page
Need help?
General
