U
SER
A
UTHENTICATION
C
OMMANDS
22-48
IP Filter Commands
This section describes commands used to configure IP management
access to the switch.
management
This command specifies the client IP addresses that are allowed
management access to the switch through various protocols. Use the no
form to restore the default setting.
Syntax
[no] management {all-client | http-client | snmp-client |
telnet-client} start-address [end-address]
• all-client - Adds IP address(es) to the SNMP, web and Telnet
groups.
• http-client - Adds IP address(es) to the web group.
• snmp-client - Adds IP address(es) to the SNMP group.
• telnet-client - Adds IP address(es) to the Telnet group.
• start-address - A single IP address, or the starting address of a range.
• end-address - The end address of a range.
Default Setting
All addresses
Command Mode
Global Configuration
Table 22-14 IP Filter Commands
Command Function Mode Page
management Configures IP addresses that are allowed
management access
GC 22-48
show management Displays the switch to be monitored or
configured from a browser
PE 22-49
To Next Page
Loading...
Need help?
General
