37-1
C
HAPTER
37
IP R
OUTING
C
OMMANDS
After you configure network interfaces for this router, you must set the
paths used to send traffic between different interfaces. If you enable
routing on this device, traffic will automatically be forwarded between all
of the local subnetworks. However, to forward traffic to devices on other
subnetworks, you can either configure fixed paths with static routing
commands, or enable a dynamic routing protocol that exchanges
information with other routers on the network to automatically determine
the best path to any subnetwork.
This section includes commands for both static and dynamic routing.
These commands are used to connect between different local subnetworks
or to connect the router to the enterprise network.
Table 37-1 IP Routing Commands
Command
Group
Function Page
Global Routing
Configuration
Configures global parameters for static and dynamic
routing, displays the routing table, and statistics for
protocols used to exchange routing information
37-2
Routing
Information
Protocol (RIP)
Configures global and interface specific parameters for
RIP
37-8
To Next Page
Need help?
General
