F
ILE
M
ANAGEMENT
C
OMMANDS
20-13
Saving or Restoring Configuration Settings
Configuration settings can be uploaded and downloaded to and from a
TFTP server. The configuration file can be later downloaded to restore
switch settings.
The configuration file can be downloaded under a new file name and then
set as the startup file, or the current startup configuration file can be
specified as the destination file to directly replace it. Note that the file
“Factory_Default_Config.cfg” can be copied to the TFTP server, but
cannot be used as the destination on the switch.
copy
This command moves (upload/download) a code image or configuration
file between the switch’s flash memory and a TFTP server. When you save
the system code or configuration settings to a file on a TFTP server, that
file can later be downloaded to the switch to restore system operation. The
success of the file transfer depends on the accessibility of the TFTP server
and the quality of the network connection.
Syntax
copy file {file | running-config | startup-config | tftp | unit}
copy running-config {file | startup-config | tftp}
copy startup-config {file | running-config | tftp}
copy tftp {file | running-config | startup-config |
https-certificate | public-key}
Table 20-5 Flash/File Commands
Command Function Mode Page
copy Copies a code image or a switch configuration
to or from flash memory or a TFTP server
PE 20-13
delete Deletes a file or code image PE 20-17
dir Displays a list of files in flash memory PE 20-18
whichboot Displays the files booted PE 20-19
boot system Specifies the file or image used to start up the
system
GC 20-20
To Next Page
General
