SMC Networks TigerStack II SMC8848M User Manual

O VERVIEW OF THE C OMMAND L INE I NTERFACE
18-10
To enter the other modes, at the configuration prompt type one of the
following commands. Use the exit or end command to return to the
Privileged Exec mode.
For example, you can use the following commands to enter interface
configuration mode, and then return to Privileged Exec mode
Table 18-2 Configuration Command Modes
Mode Command Prompt Page
Line line {console | vty} Console(config-line)# 20-22
Access
Control
List
access-list ip standard
access-list ip extended
access-list mac
access-list ipv6 standard
access-list ipv6 extended
Console(config-std-acl)
Console(config-ext-acl)
Console(config-mac-acl)
Console(config-std-ipv6-acl)
Console(config-ext-ipv6-acl)
23-3
23-3
23-17
23-10
23-10
Class
Map
class map Console(config-cmap) 32-3
DHCP ip dhcp pool Console(config-dhcp) 35-8
Interface interface {ethernet port |
port-channel id| vlan id}
Console(config-if)# 24-2
MSTP spanning-tree
mst-configuration
Console(config-mstp)# 29-10
Policy
Map
policy map Console(config-pmap) 32-5
Router router rip Console(config-router) 37-9
VLAN vlan database Console(config-vlan) 30-7
Console(config)#interface ethernet 1/5
.
.
.
Console(config-if)#exit
Console(config)#

SMC Networks TigerStack II SMC8848M Specifications

General

Device Type	Switch
Manageable	Yes
Stackable	Yes
Switching Capacity	17.6 Gbps
Forwarding Rate	13.1 Mpps
MAC Address Table Size	8K entries
Jumbo Frame Support	Yes
Form Factor	Rack-mountable
Uplink Ports	4 x Gigabit SFP
Layer	2
Power Supply	100-240V AC, 50-60Hz
Dimensions	17.3 x 1.7 in
Operating Temperature	0°C to 40°C
Storage Temperature	-4 °F to 158 °F (-20 °C to 70 °C)
Humidity	10% to 90% (non-condensing)

Summary

SECTION I GETTING STARTED

Chapter 1 Introduction

Provides an overview of the switch and basic concepts about network switches.

Chapter 2 Initial Configuration

Describes the basic settings required to access the management interface.

SECTION II SWITCH MANAGEMENT

Chapter 3 Configuring the Switch

Describes how to configure the switch via a web browser and Command Line Interface.

Chapter 4 Basic Management Tasks

Covers basic functions for management access, displaying and upgrading software, or resetting the system.

SECTION III COMMAND LINE INTERFACE

Chapter 18 Overview of the Command Line Interface

Explains how to use the Command Line Interface (CLI) for switch management.

Chapter 19 General Commands

Details commands for controlling command access mode, configuration, and other basic functions.

SECTION IV APPENDICES

Software Specifications

Details software features, management features, and supported standards.

Troubleshooting

Provides common symptoms and actions for problems accessing the management interface.

Glossary

Provides definitions of terms used throughout the manual.