O
VERVIEW
OF
THE
C
OMMAND
L
INE
I
NTERFACE
18-6
The command “show interfaces ?” will display the following information:
Partial Keyword Lookup
If you terminate a partial keyword with a question mark, alternatives that
match the initial letters are provided. (Remember not to leave a space
between the command and question mark.) For example “s?” shows all the
keywords starting with “s.”
Negating the Effect of Commands
For many configuration commands you can enter the prefix keyword “no”
to cancel the effect of a command or reset the configuration to the default
value. For example, the logging command will log system messages to a
host server. To disable logging, specify the no logging command. This
guide describes the negation effect for all applicable commands.
Using Command History
The CLI maintains a history of commands that have been entered. You
can scroll back through the history of commands by pressing the up arrow
key. Any command displayed in the history list can be executed again, or
first modified and then executed.
Using the show history command displays a longer list of recently
executed commands.
Console#show interfaces ?
counters Information of interfaces counters
protocol-vlan Protocol-vlan information
status Information of interfaces status
switchport Information of interfaces switchport
Console#
Console#show s?
snmp sntp spanning-tree ssh
startup-config system
Console#sh s
To Next Page
Loading...
Need help?
General
