Controls Description
Use the dedicated channel (Ch <1–4>) buttons to turn channel
displays on and off. The channel button is lighted when the
selected channel is on.
Use the dedicated push-to-toggle Position/Offset and Scale
knobs to adjust the vertical position and scale of the waveform.
NOTE. The Offset button is not available on MSO/DPO5000B
Series instruments.
For channel waveforms (waveforms connected to the vertical
inputs), the scale setting controls the vertical size of the
acquisition window as well as the display scale. The range and
resolution of the scale value depends on the attached probes
and on any other external factors you have specified.
For reference or math waveforms, the scale setting controls the
display only. Scaling these waveforms has no effect on the
acquisition hardware.
Use the front panel controls to display the math (M), reference
(R), bus (B), or vertical (V) setup menus.
NOTE. The M, R, B, V buttons are available only on MSO/
DPO5000B Series instruments.
Horizontal controls
Use the Horizontal controls to adjust the horizontal parameters of waveforms. The horizontal controls globally affect all displayed
waveforms.
Controls and connectors
DPO70000SX, MSO/DPO70000DX, MSO/DPO70000C, DPO7000C, and MSO/DPO5000B Series 75
To Next Page
Loading...
Need help?
General
