80 RemotEye 4 User Manual – 90988-007
Press the number of the associated selection and press [Enter].
+===================================================================+
| Toshiba RemotEye 4 Configuration Utility |
| [Interface Settings Group] |
+===================================================================+
1. RS-232 Interface: Disabled/Enabled
2. Define RS-232 Interface Protocol: Disabled/Modbus/BACnet/EMD
3. RS-485 Interface: Disabled/Enabled
4. Define RS-485 Interface Protocol: Disabled/Modbus/BACnet/EMD
0. Return to previous menu
Please Enter Your Choice => 0
Figure 9-24 Interface Settings Group Menu
RESET CONFIGURATION TO DEFAULT
Main Menu
ï‚®
(2) Reset Configuration to Default (See Figure 9-25)
This command will reset the parameters of the RemotEye 4 to the initial factory settings.
Are you sure? Y/N
Type in either Y (Yes) or N (No) to reset the RemotEye 4 to the default settings, and press [Enter].
+====================================================================+
| Toshiba RemotEye 4 Configuration Utility |
| [Firmware v1.0] |
+====================================================================+
1. RemotEye 4 Card Settings
2. Reset Configuration to Default
3. Restart SNMP/WEB Card
0. Exit
Please Enter Your Choice => 2
Are you sure ? default:[N] n
Date 02/12/2014
Time 21:58:52
Figure 9-25 Reset Configuration to Default
RESTART REMOTEYE CARD
Main Menu
ï‚®
(2) Restart SNMP/WEB Card (See Figure 9-26)
Selecting this entry will cause the RemotEye 4 to reboot.
Agent restart? Y/N
Type in either Y (Yes) or N (No) to restart the RemotEye 4 and press [Enter].
+====================================================================+
| Toshiba RemotEye 4 Configuration Utility |
| [Firmware v1.0] |
+====================================================================+
1. RemotEye 4 Card Settings
2. Reset Configuration to Default
3. Restart SNMP/WEB Card
0. Exit
Please Enter Your Choice => 3
Agent restart ?[N] n
Date 02/12/2014
Time 21:58:52
Figure 9-26 Restart SNMP/WEB Card