86 RemotEye 4 User Manual – 90988-007
UPS CONTROL CIRCUIT ERROR
CONTROL POWER SUPPLY ABNORMAL
UPS CONTROL CIRCUIT ERROR
UPS CONTROL CIRCUIT ERROR
UPS CONTROL CIRCUIT ERROR
UPS CONTROL CIRCUIT ERROR
UPS CONTROL CIRCUIT ERROR
Unknown( Any code not listed in table will be marked as unknown)
Following is a table of the possible UPS fault codes and their meanings. Please refer to UPS manual for more
specific details.
Table 10-4 UPS Fault Codes
Current limit fault occurred
DC bus over current fault occurred
DC bus over voltage occurred
DC bus imbalance occurred
Output voltage undervoltage occurred
Output voltage overvoltage occurred
Charger overvoltage occurred
Output overcurrent occurred
DC bus under voltage occurred at boostup UPS state
DC bus under voltage occurred at charging of UPS state
Inverter overload occurred and it is resettable
Inverter overload occurred and it is NOT resettable
OPERATION MODE RECORDS PAGE
This table lists the detail history of operation mode changes that has occurred on the UPS. The Log can store a
maximum of 680 records. If more events are recorded, the new record replaces the oldest record.
T1000 & 1600XP/XPi Operation Mode Records Log Format
 Log Date – This field shows the date of the recording.
ï‚· Log Time - This field shows the time that the values were recorded. Time is displayed in the hh:mm:ss 24-
hour format (i.e., 8:30 p.m. is 20:30:00).
ï‚· Record Number - Maximum number of records is 255.
ï‚· System Input Type
ï‚· System Output Type
To Next Page
Loading...
Need help?
General
