Operational environment
▪ Temperature: -35°C to +66°C
▪ Humidity: 0% to 100% non-condensing
Card Reader - Proximity Reader
▪ 125 kHz and 12.56 MHz smart credentials
▪ ISO standard 15693 and ISO 14443
▪ Card Read Range: up to 1.25” on 125 kHz proximity credentials
up to 0.75” on 13.56 MHz smart credentials
▪ 125 kHz proximity credentials compatibility:
Schlage, XceedID, HID, GE/CASE PRoxLite, AWID and LenelProx
▪ 13.56 MHz smart credential compatibility:
Secure Sector: Schlage MIFARE, aptiQ MIFARE Classic, XceedID,
aptiQ MIFARE DESFire EV1 with PACSA, aptiQ mobile
CDN Only: DESFire, HID iClasss, Inside Contactless Pico Tag,
MIFARE, MIFARE DESFire EV1, ST Microelectronics,
Texas Instruments Tag-It, Phillips I-Code
▪ Wiegand output
▪ Certifications: UL 294, UL10C, FCC Part 15, ADA, RoHS, Industry Canada (IC)
▪ ESD Protection: 12KV
Card formats: Above specified card formats up to 255-bit
Request-to-exit: built-in switch will be triggered from the activation of the door lever on the protected side of the
door.
Clutch position: Schlage NDE locks provide a way to lock or unlock a door and monitor access from a remote
location. Schlage NDE locks are fail-safe from the protected side of the door. These locksets are controlled by the
bright blue system.
Door position: built-in magnetic Door Position Switch (DPS) used to report Door Open, Door Forced or Door
Held events. Must be calibrated via ENGAGE mobile app during lock commissioning. Will report out of calibration.
GWE – ENGAGE Gateway Wiring Instructions
Power
• bright blue 12 – 24 VDC
• GWE – ENGAGE Gateway powered by bright blue or external 24 VDC power supply
bright blue to GWE – ENGAGE Gateway
• Controller to Gateway via RS-485 wiring max 4000’
To Next Page
Loading...
Need help?
General
