Configuring the WRI
Follow these steps to place the WRI into the Link Mode in order to setup proper panel address. There are two WRI
models; WRI -OTD and WRI - IN.
1 Make sure the PIM is already in link mode. See the Configuring PIM section for details.
2 Place the WRI-OTD into the link mode by pressing the reset switch.
3 Place the WRI-IN into the link mode by recycling power.
4 Go to the Link tab on the CDT screen.
5 Using the Panel drop down box select the Address (panel) of the WRI.
6 Click on the Start button. On the WRI the (LED2) will start blinking.
7 Generate a transaction by presenting any card to the reader or by pushing the tamper button. The
transactions will display on the CDT software screen. This indicates that the WRI reader has been
addressed.
8 Click on the Configuration tab. This tab is used to set the Heartbeat / First / Delay / Retry / FC Mode or Card
Number Mode.
a) The Heart Beat is used to determine how often the WRI communicates with the PIM. Leave this at
default.
b) Set the First / Delay to 300. This is required for proper operation.
c) Set the Retry to 7. This is required for proper operation.
9 Click on the Set button at the bottom of the CDT screen.
Note: A transaction may need to be produced in order for these settings to be sent to the WRI.
10 Make a note of the address as this will be used by the bright blue user interface to configure the lock.
11 Configuration of the WRI is complete. To set up another WRI follow steps 1 through 10 above.
Disconnecting WRI from the link mode
1 To disconnect WRI from the link mode, close the CDT application.
To Next Page
Loading...
Need help?
General
