Example address settings for the first of two PIMs on one channel
b) If more than one PIM is being used per channel determine how many WAPMs will interface with each
PIM and address accordingly.
Example: Channel 1 of bright blue will have two PIMs. One PIM will be interfacing with 5 WAPMs and
the other will be interfacing with 6. The first PIM will have an Addr Lo of 0 and an Addr Hi of 4. The
second PIM, when configured, will have an Addr Lo of 5 and an Addr Hi of 10.
Example address settings for the second of two PIMs on one channel
Note: If multiple PIMs are being used on the same channel it is recommended that room be left in the addressing
range for later expansion. Example: Channel 1 of bright blue will have two PIMs. At time of installation one PIM
will be interfacing with 5 WAPMs and the other will be interfacing with 6. However there may be a time when more
WAPMs will be added to these PIMs. The first PIM will have an Addr Lo of 0 and an Addr Hi of 6. This leaves
room for an additional two WAPMs to be added to this PIM at a later date. The second PIM, when configured, will
have an Addr Lo of 7 and an Addr Hi of 15. This leaves room for an additional 3 WAPMS to be added to this PIM
at a later date.
Disconnecting PIM from the link mode
1 To disconnect PIM from the link mode, close the CDT application.
To Next Page
Loading...
Need help?
General
