Xerox Phaser 8860 User Manual

09/2007
4-42
Phaser 8860/8860MFP Service Manual
REP 2.0.22, REP 3.0.1
Initial Issue
Repairs and Adjustments
REP 2.0.22 Preheater Lift Solenoid
Parts List on PL 2.0
Removal
NOTE: These steps describe Preheater lift Solenoid removal for the 8860MFP. On 8860 mod-
els, access the Preheater lift Solenoid by removing the Control Panel (REP 1.1.6). Afterwards,
return to this procedure and begin at Step 3.
1. Remove the Scanner Assembly and attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7 or REP 1.1.9 for the 8860).
4. Remove the Right Side Cover (REP 1.0.21 or REP 1.1.10 for the 8860).
5. Remove the Upper Duplex Guide (REP 3.0.5).
6. Remove the Outer Duplex Guide (REP 3.0.6).
7. Disconnect the Preheater Solenoid (P/J202).
8. Remove the screw that secures the solenoid to the Transfix Load Module.
Figure 1 Removing the Preheater Solenoid
REP 3.0.1 Inner Simplex Guide
Parts List on PL 3.0
Removal
1. Open the Front Door.
2. Raise the Lower Duplex Guide.
3. Pry inward on the 2 retainers to release them from the mounting post.
4. Slide the guide down and forward to remove it from the chassis.
Figure 1 Removing the Inner Simplex Guide
Replacement
Position the fingers on the Inner Simplex Guide over the segmented roller. Install the guide by
snapping the left side to the retaining post, then the right side.

Xerox Phaser 8860 Specifications

General

Brand	Xerox
Model	Phaser 8860
Category	All in One Printer
Language	English