09/2007
4-79
Phaser 8860/8860MFP Service Manual
ADJ 2.2.1, ADJ 2.5.1
Repairs and Adjustments
Initial Issue
Figure 2 Rotating the Drum Maintenance Camshaft
ADJ 2.5.1 Wiper Blade Alignment
Purpose
To set the Printhead Wiper Blade alignment or place the Wiper Blade in the home position.
Adjustment
To ensure Wiper Blade alignment, and place the blade in the home position, remove the drive
gear, lower the blade, and then reseat the gear.
1. Remove the Scanner Assembly with attached DADF (REP 1.0.11).
2. Remove the Output Tray (REP 1.0.6).
3. Remove the Left Side Cover (REP 1.0.7 or REP 1.1.9 on the 8860).
4. Remove the Right Side Cover (REP 1.0.21 or REP 1.1.10 on the 8860).
5. Remove the KL-Clip that secures the left side Wiper Blade Drive Gear and remove the
gear.
Figure 1 Printhead Wiper Blade Drive
6. Rotate the left and right Wiper Blade Idler Gears to lower the Wiper Blade to the bottom of
its travel. As you lower the Wiper Blade, keep the blade parallel to the Drum.
To Next Page
Loading...
Need help?
General
