Appendix
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
14-17
Configuration on the Computer
• IP addresses are managed for the entire system. Configure the settings only after consulting your
network administrator.
• When setting the network such as IP addresses with a host used under the Network Information
Service (NIS), consult your NIS administrator.
• SMB Authentication
• When an IP address or a host name is used to designate the authentication server for SMB
authentication, even if the domain name is incorrect, the authentication succeeds if the correct
user name and passcode are entered.
Files on the Computer
• If a network error occurred or the machine or the computer is disconnected during the SMB
transmission, a part of the transferred file is stored in the computer. To delete this file, delete it
manually.
• If there is a file with the same name exists on the computer, the file on the computer is
overwritten with the file sent from the machine.
Notes and Restrictions for Using TCP/IP (LPD/Port9100)
This section describes notes and restrictions to observe when using TCP/IP (LPD/Port9100).
Configuration on the Machine
• IP addresses are managed for the entire system. Configure the settings only after consulting your
network administrator.
• The setting of subnet mask and gateway addresses may be required depending on the network
environment. Consult your network administrator and configure the required settings.
Configuration on the Computer
• IP addresses are managed for the entire system. Configure the settings only after consulting your
network administrator.
• When setting the network such as IP addresses with a host used under the Network Information
Service (NIS), consult your NIS administrator.
While Printing
When you change a computer's IP address or a computer name, queries and cancel processes
submitted from the machine are no longer executed correctly. Thus, turn the machine off and on when
there is no print data in the receiving buffer.
Note You can use the machine's control panel to cancel printing of the current print data in the
machine's receiving buffer but not printing of pending print data.
Communication Restriction by IP Address
If IPv4/IPv6 address which allows communication is registered on the machine, it may be impossible to
communicate with the registered address. In this case, specify the fixed IPv4/IPv6 address on the host
and set the same address on the machine as the address to be permitted the communication.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
