Environment Settings
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
2-28
•Physical Connection
Ethernet is displayed.
Port Information
•TCP Port Number
You can set the Port9100 port No. (a value between 1 and 65535).
You must set a unique number for each port. (Default: 9100)
• Maximum Connections per Port
The maximum number of connections is displayed.
• End of Job Timeout
You can set the amount of time the machine waits before terminating the connection when
incoming data stops (between 2 and 3600 seconds). (Default: 60)
•PDL Switching
Enabled is displayed.
Apply button
You can apply changes by pressing this button.
Note Reboot the machine to enable new settings.
SMTP Server (Connectivity > Protocols)
You can set the SMTP server.
Required Information
• SMTP Server IP Address/Host Name
You can enter the SMTP server's address as an IPv4 or IPv6 address or in FQDN format (up to 256
characters).
• Port Number for Sending E-mail
You can set the port number used by the SMTP server to send an e-mail (a value between 1 and
65535). (Default: 25)
• Login Credentials for the Machine to access the SMTP Server to send automated e-mails
You can set the authentication method when sending an e-mail by SMTP. You can select None or
SMTP AUTH. (Default: None)
•Login Name
For SMTP servers requiring authentication, enter the e-mail address of the authenticated SMTP
user (between 1 to 64 ASCII code characters). This can be left blank if SMTP authentication is
skipped.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
