Product Overview
Xerox
®
WorkCentre
®
5022/5024 Multifunction Printer
User Guide
3-9
Energy Saver Modes
The machine is installed with an energy saver feature that will automatically cut off the electricity to
the machine if no copy or print data is received for a certain duration.
There are two energy saver modes: Low Power mode and Sleep mode.
Low Power mode
The machine's power is not turned off completely in Low Power mode. Instead, this mode creates a
balance between low power consumption and short warm-up time by controlling the temperature of
the fusing unit to a level midway between the power off temperature and the "Ready" temperature.
Sleep mode
Sleep mode minimizes power consumption by shutting off the power to all components except the
controller. Warm-up time in Sleep mode is longer than in Low Power mode.
Entering the Energy Saver Modes
The display of the machine status diagram goes off, and the Energy Saver button on the control panel
lights up when the machine is in an energy saver mode.
You can set the length of time to wait until the machine enters Low Power/Sleep mode.
Low Power mode is set to 1 min. and Sleep mode to 1 min. at the time of factory shipment. If the
machine is left idle for 1 minute, it switches to Low Power mode and then to Sleep mode if left idle for
another minute after that.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
