128
BALLAST WEIGHTS
E556 E557
PROCEDURE OF FILLING WATER INTO TIRES
1. Unload the tire by lifting the tractor and turn it with valve
upwards (A).
2. Deflate the tube and remove the valve insert.
3. Mount the adapter for filling of tires with water and slide the
water hose over adapter.
4. Fill the tube with prescribed quantity of liquid.
5. The gravity tank (B) or pressure water (C) can be used for
filling of tire.
6. Remove the hose and adapter for filling of tire with water.
7. Install the valve insert and inflate the tire to prescribed
inflation pressure (D).
8. Mount the valve dust cap after inflation.
9. Fill also the other tire in the same way.
PROCEDURE OF DRAINING LIQUID FROM TIRES
1. Unload the tire by lifting the tractor and turn it with valve
upwards (A).
2. Deflate the tube and remove the valve insert. Turn wheel
with valve downwards.
The under-pressure can be created in tire when
draining the liquid. Therefore turn the wheel from time
to time so that the valve could get upwards (B)!
3. Remove the rest of liquid from tire tube by means of
pressure air after assembly of adapter for filling tires with
water (C).
4. Blow out the liquid so long until no liquid runs from adapter
extension tube.
5. Remove the adapter for filing of tires with water.
6. Reinstall the valve insert and inflate the tire to prescribed
inflation pressure (D).
7. Mount the valve dust cap after inflation.
8. Drain the liquid from the other tire in the same way.
To Next Page
Loading...
Need help?
General