45
ACQUAINTANCE WITH TRACTOR
E152 E153 E154
PTO SHAFT DRIVE ENGAGEMENT
The switches on the right cab pillar are
used to engage it.
The tractor standard model is equipped
with the 6-spline end of the rear PTO
shaft.
REAR PTO SHAFT GEARSHIFT
LEVER 540 AND 1000 RPM (OR 540E)
a -
1000 rpm (or 540E)
n -
neutral
b -
540 rpm
Shifting is made with tractor at standstill.
∗Tractor can be equipped with six-,
eight- or twenty-one-spline shaft end.
Speed shifting of either 540 or
1000 rpm is possible regardless
to assembled shaft end. The PTO
shaft speed and shaft end type
must be chosen depending on
the prescribed speed of the im-
plemented machine.
REAR PTO SHAFT DRIVE CONTROL
LEVER
a -
independent speed of the PTO
shaft drive
- speed depends on the engine
speed
n -
neutral
b -
dependent speed of the trans-
mission PTO shaft
- speed depends on the gear
shifted
Shifting is made with tractor at standstill.
To Next Page
Loading...
Need help?
General