Zte ZXR10 2928 User Manual

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
168 Confidential and Proprietary Information of ZTE CORPORATION
TABLE 269 DOT1X SERVER TIMEOUT COMMAND
Format Mode Function
dot1x server-
timeout <1-
65535>
nas config This set timeout
time for
authentication
system to receive
data packets from
authentication
server
Result: This set timeout time for authentication system to
receive data packets from authentication server.
5. To set maximum times of request resending when timer
expires before authentication system receives Challenge
response from client, use command dot1x max-request
<1-10> in nas config mode. This is shown in
Table 270.
TABLE 270 DOT1X MAX REQUEST COMMAND
Format Mode Function
dot1x max-
request <1-10>
nas config This set maximum
times of request
resending when
timer expires before
authentication
system receives
Challenge response
from client
Result: This set maximum time of request resending when
timer expires before authentication system receives
Challenge response from client.
Note: 802. 1x realizes the access control by exchanging
EAPOL data packets between client system and
authentication system and RADIUS data packets between
authentication system and authentication server. During
exchange of data packets, the following parameters are
used for control purpose:
f QuietPeriod refers to the period before which
authentication system will not receive authentication
request from client system after first authentication
failure. This function can prevent the subscriber’s
continuous authentication attempts.
f TxPeriod refers to the time after which authentication
system will resend EAPOL data packets to client system
when it does not receive the response from client system.
f Supplicant Timeout and serverTimeout respectively refer
to the time during which authentication system shall
receive data packet from client system and authentication
server.

Zte ZXR10 2928 Specifications

General

Brand	Zte
Model	ZXR10 2928
Category	Switch
Language	English