Chapter 9 Network Management
Confidential and Proprietary Information of ZTE CORPORATION 231
Result: This deletes a trap.
14. To view SNMP configuration, use command show snmp
in SNMP config mode. This is shown in
Table 385.
TABLE 385 SHOW SNMP COMMAND
Format Mode Function
show snmp SNMP config This views SNMP
configuration
Result: This views SNMP configuration.
E
ND OF STEPS
SNMP has been configured.
This example describes basic configuration of SNMPv1 and
SNMPv2c
Suppose that IP address of network management server is 10.
40. 92. 105, switch has a layer 3 port with IP address of 10.
40. 92. 200, and switch is managed through network
management server.
Create a community named “zte” with read/write authority and
view named “vvv”, and then associate the community “zte” with
view “vvv”. Specify IP address of the host receiving traps as
10. 40. 92. 105, and community as “zte”.
Result
Example
To Next Page
Loading...
Need help?
General