Zte ZXR10 2928 User Manual

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
186 Confidential and Proprietary Information of ZTE CORPORATION
Configuring Syslog
This topic describes the configuration of Syslog on ZXR10
2920/2928/2952.
For the configuration of Syslog, perform the following steps.
1. To enable/disable syslog, use command set syslog in
global configuration mode. This is shown in
Table 306.
TABLE 306 SET SYSLOG COMMAND
Format Mode Function
set syslog global config This enable/disable
syslog
Result: This enable/disable syslog.
Note: By default syslog is disabled. Syslog is enabled
when there is much log information, the system
performance will degrade.
2. To define syslog information level, use command set
syslog level in global configuration mode. This is shown in
Table 307.
TABLE 307 SET SYSLOG LEVEL COMMAND
Format Mode Function
set syslog level global config This defines syslog
information level
Result: This defines syslog information level.
Note: Default level of syslog information is informational.
If level of syslog information is configured to emergencies,
the information will be sent firstly.
3. To setup syslog information receiving server, use
command set syslog {add | delete} server in global
configuration mode. At most five IP addresses of syslog
server can be configured. This is shown in
Table 308.
TABLE 308 SET SYSLOG SERVER COMMAND
Format Mode Function
set syslog {add |
delete} server
global config This setups syslog
information
receiving server
Result: This setups syslog information receiving server.
4. To enable/disable module of syslog, use command set
syslog module in global configuration mode. This is
shown in
Table 309.
Purpose
Steps

Zte ZXR10 2928 Specifications

General

MAC Address Table Size	16K
VLAN	4K
Jumbo Frame	9K
Power Supply	AC 100-240V, 50/60Hz
Power Consumption	< 30W
Dimensions	440mm x 200mm x 44mm
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Ports	24 x 10/100/1000Base-T ports, 4 x GE SFP ports