Zte ZXR10 2928 User Manual

Chapter 7 Service Configuration
Confidential and Proprietary Information of ZTE CORPORATION 75
Format Mode Function
show port
<portlist> qos
Global
config
This displays the QoS configuration
data of the port
Result: This displays the QoS configuration data of the port.
5. To display the bandwidth information of the port, use
command show port <portlist> bandwidth session <0-3>
in global configuration mode. This is shown in
Table 58.
TABLE 58 SHOW PORT BANDWIDTH COMMAND
Format Mode Function
show port
<portlist>
bandwidth
session <0-3>
Global
config
This displays the bandwidth
information of the port
Result: This displays the bandwidth information of the port.
E
ND OF STEPS
Port information is displayed.
Port Mirroring
Port mirroring is used to mirror data packets of the switch port
(ingress mirroring port) to an ingress destination port (ingress
monitoring port), or mirror the data packets of the switch port
(egress mirroring port) to an egress destination port (egress
monitoring port).
Through mirroring, data packets flowing in or out of a certain
port can be monitored. Port mirroring provides an effective
tool for the maintenance and monitoring of the switch.
Switch can be configured with only one ingress monitoring port
and one egress monitoring port. Ingress monitoring port and
egress monitoring port can be configured on same port.
Whereas multiple source ingress monitoring ports and source
egress monitoring ports can be configured at the same time.
Note: In default case, switch does not have mirroring port.
The GOOD data packets received by ingress mirroring port are
mirrored onto the monitoring ports, but data packets directly
discarded on the ingress port (for example, because of CRC
errors) are not mirrored. The source mirror port & the
destination port must be in the same vlan.
Configuring Port Mirroring
Result
Introduction
Purpose

Zte ZXR10 2928 Specifications

General

Brand	Zte
Model	ZXR10 2928
Category	Switch
Language	English