ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
244 Confidential and Proprietary Information of ZTE CORPORATION
2. To enable/disable port ZDP function, use command set
zdp port <portlist> {enable|disable} in group config
mode. This is shown in
Table 393.
TABLE 393 SET ZDP PORT COMMAND
Format Mode Function
set zdp port
<portlist>
{enable|disable}
group config This enable/disable
port ZDP function
Result: This enable/disable port ZDP function.
3. To enable/disable trunk ZDP function, use command set
zdp trunk <trunklist> {enable|disable} in group config
mode. This is shown in
Table 394.
TABLE 394 SET ZDP TRUNK COMMAND
Format Mode Function
set zdp trunk
<trunklist>
{enable|disable}
group config This enable/disable
trunk ZDP function
Result: This enable/disable trunk ZDP function.
Important! By default, ZDP functions of all ports/trunks are
enabled. When ZDP function of a port/trunk is disabled,
contents of neighbor device information table of port/trunk
are cleared, and ZDP packets processing is suspended.
Note: A port/trunk can collect and send ZDP information
normally only when both ZDP function of port/trunk and
system ZDP function are enabled.
4. To set time interval for sending ZDP packets, use
command set zdp holdtime <10-255> in group config
mode. This is shown in
Table 395.
TABLE 395 SET ZDP HOLDTIME COMMAND
Format Mode Function
set zdp holdtime
<10-255>
group config This set time
interval for sending
ZDP packets
Result: This sets the time interval for sending ZDP packets.
Note: ZDP holdtime value should be bigger than time value,
here give the advice that the holdtime value is three times of
time value.
5. To set time interval for sending ZDP packets, use
command set zdp timer <5-255> in group config mode.
This is shown in
Table 396.
To Next Page
Need help?
General