Zte ZXR10 2928 User Manual

ZXR10 2920/2928/2952
(V1.0) Access Switch User Manual （Volume I）
184 Confidential and Proprietary Information of ZTE CORPORATION
11. To clear SQinQ session in port, use command clear
sqinq-session <sessionlist> in global configuration mode.
This is shown in
Table 303.
TABLE 303 CLEAR SQINQ SESSION COMMAND
Format Mode Function
clear sqinq-
session
<sessionlist>
global config This clears SQinQ
session in port
Result: This clear SQinQ session in port.
12. To view parameters of SQinQ session use command show
sqinq-session [<sessionlist>] in global configuration mode.
This is shown in
Table 304.
TABLE 304 SHOW SQINQ SESSION COMMAND
Format Mode Function
show sqinq-
session
[<sessionlist>]
global config This views
parameters of
SQinQ session
Result: This views parameters of SQinQ session.
E
ND OF STEPS
SQinQ strategy policy has been configured.
This example describes that there are two switches of ZXR10-
5124 (Switch A and Switch B) in Service Provider Network.
Port 24 of Switch A is connected to port 24 of Switch B. Vlan1-
200 is in port 1 through 6 of Switch A which communicate with
port 1 through 3 of Switch B in which Uplink vlanid assigned as
100. Vlan201-4094 is in port 1 through 6 of Switch A which
communicates with port 4 though 6 of Switch B in which Uplink
vlanid assigned as 200. Customer Port of Switch A is untag
port only for Vlan1.
Configuration of Switch A
zte(cfg)#set sqinq-session 1 customer-vlan 1-200 uplink-
vlan 100
zte(cfg)#set port 1-6 sqinq-session 1 enable
zte(cfg)#set vlan 100 enable
zte(cfg)#set vlan 100 add port 1-6 untag
zte(cfg)#set vlan 100 add port 24 tag
zte(cfg)#set sqinq-session 2 customer-vlan 201-4094
uplink-vlan 200
zte(cfg)#set port 1-6 sqinq-session 2 enable
zte(cfg)#set vlan 200 enable
zte(cfg)#set vlan 200 add port 1-6 untag
zte(cfg)#set vlan 200 add port 24 tag
Result
Example

Zte ZXR10 2928 Specifications

General

Brand	Zte
Model	ZXR10 2928
Category	Switch
Language	English