Zte ZXR10 2928 User Manual

Chapter 8 Access Service
Confidential and Proprietary Information of ZTE CORPORATION 191
GARP has been configured.
Configuring GVRP
This topic describes the configuration of GVRP.
For the configuration of GVRP, perform the following steps.
1. To enable/disable GVRP, use command set gvrp in
global configuration mode. This is shown in
Table 318.
TABLE 318 SET GVRP COMMAND
Format Mode Function
set gvrp global config This enable/disable
GVRP
Result: This enable/disable GVRP.
Note: By default, GVRP is disabled. GVRP is only enabled
when GARP is enabled.
2. To enable/disable GVRP in port, use command set gvrp
port <portlist> {enable|disable} in global configuration
mode. This is shown in
Table 319.
TABLE 319 SET GVRP PORT COMMAND
Format Mode Function
set gvrp port
<portlist>
{enable|disable}
global config This enable/disable
GVRP in port
Result: This enable/disable GVRP in port.
Note: By default, GVRP in port is disabled. After enabling
GVRP in port, the port can receive packets of GVRP protocol.
3. To configure type of GVRP registration in port, use
command set gvrp port <portlist> registration
{normal|fixed|forbidden} in global configuration mode.
This is shown in
Table 320.
TABLE 320 SET GVRP PORT REGISTRATION COMMAND
Format Mode Function
set gvrp port <portlist>
registration
{normal|fixed|forbidden}
global config This configure
type of GVRP
registration in
port
Result: This configures type of GVRP registration in port.
Note: By default, system port GVRP registration status is
normal, this command is to setup port GVRP registration
type. There are three types of registration types:
Result
Purpose
Steps

Zte ZXR10 2928 Specifications

General

Brand	Zte
Model	ZXR10 2928
Category	Switch
Language	English