Zte ZXR10 2928 User Manual

Chapter 9 Network Management
Confidential and Proprietary Information of ZTE CORPORATION 229
Format Mode Function
belongs to and its
security attribute
Result: This sets user name, group it belongs to and its
security attribute.
f Security attribute of user includes authentication and
cryptogram, arithmetic of authentication and encrypting
(MD5\SHA\DES). Security level of user and group
should be accordant.
6. To set engine identifier, use command set engineID in
SNMP config mode. This is shown in
Table 377.
TABLE 377 SET ENGINEID COMMAND
Format Mode Function
set engineID SNMP config This sets engine
identifier
Result: This sets engine identifier.
Note: EngineID identifies a SNMP entity uniquely. When it
is changed, configurations of primary engineID don’t work
any longer.
7. To set the address, community name and version of trap
or inform host, use command set host in SNMP config mode.
This is shown in
Table 378.
TABLE 378 SET HOST COMMAND
Format Mode Function
set host SNMP config This sets address
Result: This set address community name and version of
trap or inform host.
f Host is destination IP address sending by trap or inform.
It can designate the version of trap and inform and
community or user.
8. To enable/disable SNMP trap, use command set trap in
SNMP config mode. This is shown in
Table 379.
TABLE 379 SET TRAP COMMAND
Format Mode Function
set trap SNMP config This enable/disable
SNMP trap
Result: This enable/disable SNMP trap.
f When it is enabled, operation as described in 5) above
occurs, a trap is sent to the management console. The
cold start and warm start traps are sent to management

Zte ZXR10 2928 Specifications

General

Brand	Zte
Model	ZXR10 2928
Category	Switch
Language	English