MECHANICAL INSTALLATION
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
109/266
4. Pull out the cables, but leave them connected.
5. Put two pieces of square timber on the adjacent heat exchanger and place the
removed heat exchanger on the timber.
6. Join the DC busbars with the supplied installation material.
5.8.2.2. Reinstalling an air-to-air heat exchanger
1. Move the heat exchanger to its original position.
2. Pull the cables down towards the terminal box.
3. Move the heat exchanger to its exact position.
4. Fix the cables with cable ties at regular distances of approximately 20 cm.
5. Tighten all screws of the heat exchanger.
6. Fix the cables inside the terminal box with cable ties.
To Next Page
Loading...
Need help?
General
