CDP CONTROL PANEL
PRODUCT
ACS6000
DOCUMENT KIND
User manual
DOCUMENT ID.
3BHS212794 E01
REV.
N
LANG.
en
PAGE
203/266
9.2.5.1. Local control
In local control mode, full operational control of the drive is enabled from the local
operator panel. Commands from remote have no effect.
– To enter the local control mode, press the LOC-REM key.
Local control is indicated by the letter L.
9.2.5.2. Disabling / enabling local lock function
Accidental switching from remote control to local control can be prevented with
the local lock function.
The corresponding parameter is 16.04 LOCAL LOCK and belongs to the parameter
group 16 SYSTEM CTRL INPUTS.
9.2.5.3. Enabling the local lock
– To enable the local lock, set parameter 16.04 to 2 (LOCKED).
With this parameter setting, local control (including the LOC-REM key) is
disabled.
If the CDP control panel or a DriveWindow PC is in local control mode at the
time that the local lock is enabled, they remain in local control mode until they
are switched to remote control mode. This means that the CDP control panel
displays the letter L until you press the LOC-REM key.
9.2.5.3.1 Disabling the local lock
– To disable the local lock, set parameter 16.04 to 1 (OPEN).
With this parameter setting, switching between remote and local control is
enabled.
LOC
REM
1 L -> 600.0 rpm 0
StateINU ReadyRun
MOTOR SP 0.00 rpm
POWER 0.0 kW
To Next Page
Need help?
General
